DEPS_250 Posted May 14, 2023 Report Share Posted May 14, 2023 (edited) Does anyone know if the Owner ST-36 stinger treble is resistant to rust/corrosion in saltwater? Product description says it's corrosion resistant so I assume it is. I always change out all my hooks on my freshwater hard baits to Owner ST-36. I usually fish saltwater hard baits and lures that come with salt water approved hooks already so I don't have to worry about rust and corrosion. On the other hand, I want to start throwing some freshwater hard baits and glide baits in the salt more for calico, spottie, halibut and striper fishing. I have never tried Owner ST-36 trebles in the salt before. I don't want to have to go out and buy saltwater approved treble hooks if the ST-36 would still work just fine in the salt. Edited May 14, 2023 by DEPS_250 Quote Link to comment Share on other sites More sharing options...
BASS_SWINGER Posted May 14, 2023 Report Share Posted May 14, 2023 I’m going to go out and say it’s not targeted for salt at all obviously it will provide some amount of corrosion resistance either the black coating but it is what it is Quote Link to comment Share on other sites More sharing options...
Morgan Y Posted May 14, 2023 Report Share Posted May 14, 2023 It’s not really geared towards it. The galvanized “saltwater” hooks seem to be a lot better for it as their name states. Teflon coated hooks also do well. If you wash your baits with freshwater after your day on the water I’d wager a guess that most hooks would be fine but in the event you forget a nickel coated hook isn’t going to make it. Quote Link to comment Share on other sites More sharing options...
kookfarmer Posted May 14, 2023 Report Share Posted May 14, 2023 Everything rusts in the salt flaswimbaiter and _freddyroots 2 Quote Link to comment Share on other sites More sharing options...
B_larkin3 Posted May 14, 2023 Report Share Posted May 14, 2023 I’ve used the ST36 in sw on jerkbaits but only on lighter spinning setups with light line (15 lb braid) . If you’re tossing swim baits in saltwater I’d step up to a ST 56. I don’t know about the other species you mentioned but a decent size striper will mangle an ST36. As for owner hooks, they will hold up in saltwater as long as you rinse them off after every use. Jim137a 1 Quote Link to comment Share on other sites More sharing options...
kookfarmer Posted May 14, 2023 Report Share Posted May 14, 2023 I fish st66 on most everything Quote Link to comment Share on other sites More sharing options...
SDBayBassMan Posted May 14, 2023 Report Share Posted May 14, 2023 I would agree with @kookfarmer I typically put an Owner ST-56 or St-66 on all my baits. My go to size for is usually a Size 1 across the board on all my baits. Hope that helps. kookfarmer 1 Quote Link to comment Share on other sites More sharing options...
Bakerlounge Posted May 15, 2023 Report Share Posted May 15, 2023 I have used ST-36 hooks with no issue in the salt, rinse them off and they will be fine, but eventually salt water gets to everything. I agree with the previous comments and typically use ST-56's or 66's in the salt because of the added weight and strength fighting mean saltwater bass that destroy everything. Bassmann86 and SDBayBassMan 2 Quote Link to comment Share on other sites More sharing options...
Efrain Posted May 15, 2023 Report Share Posted May 15, 2023 11 hours ago, DEPS_250 said: Does anyone know if the Owner ST-36 stinger treble is resistant to rust/corrosion in saltwater? Product description says it's corrosion resistant so I assume it is. I always change out all my hooks on my freshwater hard baits to Owner ST-36. I usually fish saltwater hard baits and lures that come with salt water approved hooks already so I don't have to worry about rust and corrosion. On the other hand, I want to start throwing some freshwater hard baits and glide baits in the salt more for calico, spottie, halibut and striper fishing. I have never tried Owner ST-36 trebles in the salt before. I don't want to have to go out and buy saltwater approved treble hooks if the ST-36 would still work just fine in the salt. I rinse off all the lures I used during a salt session. Never had any problem with them rusting this way. Most of my hooks are owner as well btw Quote Link to comment Share on other sites More sharing options...
DEPS_250 Posted May 15, 2023 Author Report Share Posted May 15, 2023 19 hours ago, Morgan Y said: It’s not really geared towards it. The galvanized “saltwater” hooks seem to be a lot better for it as their name states. Teflon coated hooks also do well. If you wash your baits with freshwater after your day on the water I’d wager a guess that most hooks would be fine but in the event you forget a nickel coated hook isn’t going to make it. 18 hours ago, kookfarmer said: Everything rusts in the salt Trust me, I learned the hard way. I took out an expensive Japanese freshwater hard bait to a local brackish water pond a few months ago and forgot to rinse off the bait after the session. A few days later I open the box and the hooks and split rings all rusted out. It wasn't the end of the world since all I had to do was replace the split rings and hooks. But then again, it is an expensive bait so I was kind of bummed out on losing 2 perfectly good hooks from the get go. Lesson learned, I need to remember to now wash my baits after every saltwater session or I will risk losing hooks. Morgan Y 1 Quote Link to comment Share on other sites More sharing options...
DEPS_250 Posted May 15, 2023 Author Report Share Posted May 15, 2023 Do you rinse with warm water and soap? Is soap even needed at all? Should you rinse the baits 'immediately' after fishing or can you wait a few hours and still be good? Some fishing spots I go to are pretty far from home, therefore it usually takes me anywhere from 1-3 hours to get back home after a saltwater session. Can I wait the 1-3 hours and still be good or should I rinse 'immediately' right after fishing? I have heard of a product called 'Salt Away' that saltwater anglers/boat owners use to clean engines and stuff. Is it recommended to wash your baits with Salt Away in order to be sure there will not be any kind of corrosion or rust at all? I guess it doesn't hurt to use it in order to have some extra insurance/peace of mind. Quote Link to comment Share on other sites More sharing options...
Morgan Y Posted May 15, 2023 Report Share Posted May 15, 2023 1 hour ago, DEPS_250 said: Do you rinse with warm water and soap? Is soap even needed at all? Should you rinse the baits 'immediately' after fishing or can you wait a few hours and still be good? Some fishing spots I go to are pretty far from home, therefore it usually takes me anywhere from 1-3 hours to get back home after a saltwater session. Can I wait the 1-3 hours and still be good or should I rinse 'immediately' right after fishing? I have heard of a product called 'Salt Away' that saltwater anglers/boat owners use to clean engines and stuff. Is it recommended to wash your baits with Salt Away in order to be sure there will not be any kind of corrosion or rust at all? I guess it doesn't hurt to use it in order to have some extra insurance/peace of mind. In the salt experience that I have it seems like washing stuff off within the day using warm water which more easily dissolves and removes salt is more than enough. Of course there will be micro corrosion the longer that you leave the salt on but it isn't a process that is going to completely destroy your tackle within the day, especially if the coating prevents a salt to steel connection like teflon or a galvanized layer would do. Also on top of the coating if I had to wager a guess saltwater hooks are likely made out of steels with a high stainless carbide content which makes them inherently more resistant to rust even if you forget to wash your baits. Quote Link to comment Share on other sites More sharing options...
flaswimbaiter Posted May 16, 2023 Report Share Posted May 16, 2023 I use ST 56 hooks and rinse well. If they get rusty but are still sharp I will put a little food based oil on them before storing away. Quote Link to comment Share on other sites More sharing options...
SDBayBassMan Posted May 24, 2023 Report Share Posted May 24, 2023 @DEPS_250 To follow up from your previous question and having consistently dealt with the rust issue, I’d recommend just rinsing the baits off very well with freshwater, doesn’t need to be warm water, but essentially enough water to get the salt off. The key and most critical part (in my opinion) is allowing the bait to air dry outside of your bag or box after the rinse — and separate from all your other baits. If you do that, it definitely mitigates the issue. I’ve never sprayed salt away on my baits, although I’m sure that would work too, but air drying after a freshwater rinse would be my main recommendation as it’s worked for me and is the only thing I do. kookfarmer 1 Quote Link to comment Share on other sites More sharing options...
kookfarmer Posted May 24, 2023 Report Share Posted May 24, 2023 4 hours ago, SDBayBassMan said: @DEPS_250 To follow up from your previous question and having consistently dealt with the rust issue, I’d recommend just rinsing the baits off very well with freshwater, doesn’t need to be warm water, but essentially enough water to get the salt off. The key and most critical part (in my opinion) is allowing the bait to air dry outside of your bag or box after the rinse — and separate from all your other baits. If you do that, it definitely mitigates the issue. I’ve never sprayed salt away on my baits, although I’m sure that would work too, but air drying after a freshwater rinse would be my main recommendation as it’s worked for me and is the only thing I do. Listen to this man. He’s learned me a lot over the last couple years. SDBayBassMan 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.